Tool insulation systems have become critical to the processing capabilities and efficiencies of all plastic and rubber processors. UniTherm provides systems, in a variety of configurations to accommodate your needs... from customized blankets for sheet dies, blown film dies and thermoset molds to insulation boards for low and high compression applications. Each system allows for maximum efficiency and control of tool/mold temperature, faster start-up times and reduced strain on plant cooling systems. Tool insulation can be customized to a specific tool or generalized to adopt to a variety of tool sizes and configurations. And are designed with convenience in mind with access for all adjustment areas and quick connect hardware for easy removal and replacement.

You should not insulate if:
1. There is a lot of shear heat.
2. Your machine is air-cooled.

Thank you for letting us take a moment of your time to explain the benefits of using an insulation system made or designed to your specific need.

OSHA STANDARD REQUIREMENTS

Regulations (Standards - 29 CFR)

Safeguards for personnel protection. - 1910.335

Regulations (Standards - 29 CFR) - Table of Contents

• Part Number: 1910

• Part Title: Occupational Safety and Health Standards

• Subpart: S

• Subpart Title: Electrical

• Standard Number: 1910.335

• Title: Safeguards for personnel protection.

Protective shields, protective barriers, or insulating materials shall be used to protect each employee from shock, burns, or other electrically related injuries while that employee is working near exposed energized parts which might be accidentally contacted or where dangerous electric heating or arcing might occur. When normally enclosed live parts are exposed for maintenance or repair, they shall be guarded to protect unqualified persons from contact with the live parts. ..1910.335(b)